Excellent heat recovery (PAT.)
Compact, high output heater (72W) combined with a high sensitivity sensor means there is almost no temperature fluctuation during heavy load continuous operation.
Fastest in its class
Reaches set temperature in just 6 seconds after turning power on. Turn on and start work immediately. No wasted time.
Easy to replace tip without using tools
With the new slide-change tip there is no need for heat-resistant pads or tools when changing the tip. (PAT.P)
All-in-one tip design
Heater and sensor included in the tip making maintenance and changing tips easy.
Anti-oxidation tip(PAT.)
Tips designed with fine solder coated grooves to stop oxidation. (RX-80HRT-BM only)
Reduced heat-up of soldering unit grip
Newly designed thermal insulation soldering unit construction (PAT.P) to reduce heat transfer to the grip.
Thick iron plating for lead-free soldering
All tips with thick iron plating to prevent slow erosion caused by lead-free soldering.
High/Low Temperature Alarm
An alarm sounds (to alert the user) when the temperature goes outside (above or below) the maximum or minimum temperature settings. High/low setting range 3¡ëC~100¡ëC.
Intelligent Sleep Function (PAT.)
Automatically lowers the tip temperature when inactive for a preset period of time, preventing overheating. User definable preset time. (Can be used in conjunction with Shutdown function.)
Intelligent Sleep Function (PAT.)
Automatically lowers the tip temperature when inactive for a preset period of time, preventing overheating. User definable preset time. (Can be used in conjunction with Shutdown function.)
Sleep function release (PAT.P)
Sleep mode can be exited by touching a wet sponge with the tip to cause temperature fluctuation.
Shutdown function
The unit automatically shuts down when not used for a preset period of time. This means that the unit turns itself off, if you forget to!
Advanced Alarm Function (To prevent overheating)
Alarm sounds if the iron is left in contact with the component longer than the specified/set time. This prevents inexperienced operators from overheating the component, and in turn helping quality control.
Calibration Function (PAT.)
The calibration function digitally offsets the difference between the tip temperature and the temperature shown by a tip thermometer being used.
New ergonomic design soldering unit (PAT.)
New ergonomically designed soldering unit provides comfortable usability, easy handling and a shorter distance from grip to tip.
Reliable traceability
We can provide periodic calibration of the unit if required and issue certification necessary for various purposes.
Handpiece rubber grip (Anti-static)
Four colours to differentiate between stations, tasks or types of solder being used.
Note: Cannot be used with RX-802ASPH
How to Change the Soldering Unit Tip
To remove the soldering unit tip, slide the lever in the direction of the arrow. The tip will then protrude from the hand piece and can be removed easily by holding and pulling the plastic housing of the integrated tip/heater. 
Specifications
| MODEL |
RX-802AS |
| Voltage |
110V,120V,130V,220V,230V,240V AC 50/60Hz |
| Power Consumption |
80W |
| Soldering Unit Voltage/ Consumption |
24V AC/72W |
| Temperature Setting Range |
Room temp.-450°C |
| Dimensions |
Control Unit |
158mm ( w/o cord bushing ) |
| Soldering Unit |
146(L)×115(W)×98(H)mm |
| Weight |
Control Unit |
Approx. 27g ( w/o cord ) |
| Soldering Unit |
Approx. 1.8kg ( w/o cord ) |
| Leak Voltage |
Less than 2mV |
| Ground Resistance |
Less than 2Ω
|
| Control Unit to Soldering Unit Cord Length |
1.2m
|
| Power Cord Length |
1.2m (3 core cord) ground plug |
| Accessory |
Soldering Iron Stand (ST-20) |
